Visit our Competence Center!
Arrange your visit now
Spiro® Shaper
The Spiro® Shaper stands out with the efficiency to mount gaskets in a fast and
accurate fashion on fittings.
The focus on smaller diameter range (100 – 500 mm) results in a high output volume combined with consistency due to the precise machine set-up. Moreover, the Spiro® Shaper can produce a rolled edge on non-gasket products.
In addition, the machine handles any type of fittings (e.g. saddle, bends, T-pieces). Also, to optimize the leakage tightness, Spiro® implemented 5 different widths of rubber gaskets, covering the entire dimension range.
Combine the Fittingshaper 1250 & Spiro® Shaper to achieve the full dimension range of rubber gasket on your fittings!
Technical Data
| Diameter Range: | 100 – 500 mm (4”- 20”) |
| Material Thickness: | 0.5 - 0.9 mm (0,020”- 0,035”) galvanized steel 0.5 - 0.8 mm (0,020”- 0,031”) stainless steel |
| Power Supply: | 400V / 50Hz / 3 Phases (other voltage on request) |
| Pneumatic Connection: | 7 bar, 200 l/min. (as required minimum) |
