Spiro® Shaper - The full range of reducers, couplings and bends can be equipped with the self-sealed system

Spiro® Shaper

The full range of reducers, couplings and bends can be equipped with the self sealed system

The Spiro® Shaper stands out with the efficiency to mount gaskets in a fast and accurate fashion on fittings. The focus on smaller diameter range (100 – 500 mm) results in a high output volume combined with consistency due to the precise machine set-up.

Moreover, the Spiro® Shaper can produce a rolled edge on non-gasket products. In addition, the machine handles any type of fittings (e.g. saddle, bends, T-pieces). Also, to optimize the leakage tightness, Spiro® implemented 5 different widths of rubber gaskets, covering the entire dimension range.

Combine the Fittingshaper 1250 & Spiro® Shaper to achieve the full dimension range of rubber gasket on your fittings!

Spiro® Shaper - short

Technical Data
Spiro® Shaper1
Spiro® Shaper2
Spiro® Shaper3
Spiro® Shaper4
Spiro® Shaper5
Spiro® Shaper6
Spiro® Shaper7
Diameter Range 100 – 500 mm (4”- 20”)
Material Thickness

0.5 - 0.9 mm (0.020”- 0.035”) galvanized steel
0.5 - 0.8 mm (0.020”- 0.031”) stainless steel

Power Supply 400V / 50Hz / 3 Phases (other voltage on request)
Pneumatic Connection 7 bar, 200 l/min. (as required minimum)
Maximum Output 4-6 pcs/min. of 2-gasket fittings (Ø160 mm)